Lbl-lighting Fusion Jack 1.5" Low Profile Canopy Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Osvětlení Lbl-lighting Fusion Jack 1.5" Low Profile Canopy. LBL Lighting Fusion Jack 1.5" Low Profile Canopy User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 4
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
1
GENERAL PRODUCT INFORMATION:
This product is suitable for dry locations only.
Prior to the steps below, make sure that the remote
transformer(s) and all power connections are installed
according to local electrical codes.
REMOTE
TRANSFORMER
JUNCTION BOX
PORT #1 PORT #3 PORT #5
PORT #2 PORT #4 PORT #6
Run Power from the Remote
Transformer(s) to the Ports
Run the power from the remote transformer to a junction
box, refer to the voltage drop chart provided in the
transformer documentation. For 600 watt remote
transformer with dual circuit breakers, a junction box for
each circuit will be required.
Branch the power from the junction box to each port. For
recommended wire size, refer to the chart below. Note
that each power branch should be no longer than 20'.
Transformer
Wattage
Wire Size For
20W Port
150W
300W
#14 GA
#14 GA
Wire Size For
50W Port
Wire Size For
75W Port
#12 GA #10 GA
#12 GA #10 GA
300W
#18 GA
#18 GA #16 GA
Transformer
Voltage
12V
12V
24V
Installation Instructions for
Port Alone
950FJPRTA
1.0
SINGLE PORTS
700FJFCP_, CK001P-FJ-_
1
2
1
222222
1A
Zobrazit stránku 0
1 2 3 4

Shrnutí obsahu

Strany 1 - Transformer(s) to the Ports

1GENERAL PRODUCT INFORMATION:This product is suitable for dry locations only.Prior to the steps below, make sure that the remotetransformer(s) and all

Strany 2 - Install the Single Port Alone

2Using a split bolt connector, connect the low voltage hotwire coming from the remote transformer to each hot wiregoing to the ports.Connect the low v

Strany 3

3EDGE OFTHE PORTWIRE NUTPlace the wire nut connections and the port wiresproperly inside the port. Make sure that the port and lowvoltage wires are cl

Strany 4 - SAVE THESE INSTRUCTIONS!

4Connect the Fixture to the PortCONNECTORPORTScrew the fixture connector completely into the port.13A17400 Linder Ave, Skokie, IL 60077847.410.4400www

Komentáře k této Příručce

Žádné komentáře