Lbl-lighting Vision Uživatelský manuál stáhnout pdf

GENERAL PRODUCT INFORMATION:

This product is ETL listed and suitable only for indoor dry locations

and approved for use at any height above the finished floor.

CAUTION - RISK OF FIRE

This product requires installation by a qualified

electrician. Before installing be sure to read all

instructions and TURN THE POWER TO THE

ELECTRICAL BOX OFF.

Fusion Jack™

Installation Instructions for

Visions

1.4

HS336_1A35FSJ

980FSJVISNP

Install the Lamp and Disk

LAMP

SOCKET

Align and push the lamp pins completely into the socket holes.

Orient the recessed section of the crystal glass disk toward

the lamp. Place edge of the crystal disk into curved section of

accessory springs.

Use MAX 35 Watt MR11 Front Cover Halogen

Lamp .

CURVED

SECTION

CRYSTAL

GLASS DISK

ACCESSORY

SPRINGS

CURVED

SECTION

NOTE: The Crystal disk must be removed when relamping.

NOTE: To reduce the risk of a burn or electric shock

during relamping, disconnect the power to the fixture.

1A 1B

1 2 3 4

Shrnutí obsahu

Strany 1 - Visions

GENERAL PRODUCT INFORMATION:This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finishe

Strany 2 - Adjust the Fixture Height

2Adjust the Fixture HeightBack out (do not remove) the set screw on tip of the connector with the provided Allen wrench.Back out (do not remove) the s

Strany 3

332HFirmly tighten the set screw on the conical connector.1010Pull the coaxial cable toward the fixture to smooth the wrinkles.2I1111

Strany 4 - Lamp Life

IMPORTANT SAFETY INSTRUCTIONSTo reduce the risk of fire, electrical shock, exposure to excessive UV radiation, or injury to person:– Use this fixture